if you dont find any other solutions, you might check for burrs as 68 stepside suggested......& also make sure there is a good chamfer on the lead in edge of the hole. I think I would "mike up" the hole & the OD of the bushing, & if needed have a little skinned off the Od of the bushing. You shouldnt need more than about a .002 press fit on the bushing. Good luck,crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|
10-24-2003, 04:38 PM
Threaded Mode