|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-07-2012, 10:23 AM
|
#1 |
|
Registered User
Join Date: Jun 2010
Location: El Chuco
Posts: 30
|
Help! Intake and exhuast gaskets on inline 250????
Hey everyone, I have a question in regards to the intake and exhaust manifold gaskets, trying to figure out the mating or installation of the gaskets. I Know on the gasket that mounts to the header the flat side goes towards the header with the metal facing the intake and exhaust ports am I correct on this???? the one that is baffleing me is the one for in between the the intake and exhuast below the carb, I have two gaskets one that is solid and one that is just the outline of the manifold, so which one goes in there and which way does the metal side face, intake or exhaust side???? Keep in mind this is for a stock inline 250, I have searched but cant find any info on this so I appreciate everyones help on this. Thanks...............
__________________
Dennis N. USN Ret. Patriotism is your conviction that this country is superior to all other countries because you were born in it. 
|
|
|
| Bookmarks |
|
|
Threaded Mode