![]() |
![]() |
#1 |
Pronounced "Pew-al-up"
Join Date: Oct 2002
Location: Puyallup, Washington
Posts: 845
|
Cam timing
I have a decent book on engine rebuild, but have a question concerning reinstalling my new cam.
I have #1 piston at TDC just by turning over the engine until I see the cylinder fully extended. Are there marks I should be looking for to align the cam to the crank correctly?? I also bought the new timing set and want to make sure it goes on right as far as the three Keyways?? Hope this makes sense, I am a newbie to engines!! Thanks, Dan ![]()
__________________
Classic GM Trucks of Washington Club Member 1970 FS chevy,350/350, Edelbrock cam and intake. Holley 650 carb,HEI,AT,Tangier Orange, 18's, Power Locks, Truck Photos |
![]() |
![]() |
Bookmarks |
|
|