TN Big Block Tig Welded Custom Exhaust..

[dhart]

If you have or you are building a big block for a 67-72 C-10 I can tell you this is as nice of a professionally built exhaust system you will find.
It was built by a local high end fabricator here in Memphis and I can send you a link to his site if needed.
It was built for a high end 67- C-10 with a 565 fuel injected big block and it will fit fine on any standard short deck block and heads from 402-632.
It consists of 2 1/4 primary tubes, merge collectors to 3 inch Heddman x pipe and extensions. It was all hand tig welded, pipes are numbered and then sent out for jet hot coating.
I can tell you the fit is great with good ground clearance as well, two tubes go over the frame and plug access is excellent. This is not a one size fits most set of hookers, the build quality is as good or better than a set of Lemons headers.
The cost of this system was around 2000.00 It was used for around 2500 miles and pulled for a top shelf L/S swap.
I bought the engine and all associated parts that I am installing in my chevelle. I wanted to keep the exhaust for a future c-10 project but have decided to pass it on.
No issues with this one, no leaks, very very nice!
875.00 firm....... Reduced 750.00 plus shipping!
shipping 100.00 continental u.s.
Also these may very well fit 73-87 as they are very similar frame and cab setup.