|
06-17-2013, 11:18 PM
|
#1 |
|
low n' slo
 
Join Date: Mar 2009
Location: rosenberg, texas
Posts: 5,175
|
Steering gearbox seal
after getting my ps pump together and running it a little bit, it was leaking bad where the shaft goes into the pump. sooo, i read a lot of how to's and it seemed easy enough. after getting the input shaft out and changing the seal...im having a tough time getting it back in. i counted the threads before taking it out (counted 4)...as i dropped it back in, started threading fine and about 4 threads from where i need to be, it is super tough to turn..like almost impossible. i know im not using the correct wrench for the holes, but damn i didn't think it would be that hard to turn only halfway to where it needs to be. is there something i did wrong or is it as simple as getting the right wrench to turn it...?
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread  -_--_--_ _________ _--_-_ -/____|__|__\__ ,.,,,.,.,,.,|_O _______ O_] |
|
|
| Bookmarks |
|
|
Threaded Mode