project: 3/4 ton dropped

[cleansquare]

Originally Posted by 79 blue monster

i went to performance online and got everything i needed. i bought drop spindles($399) and i cut a half coil out of my front springs. my crossmember sits about 2-3 in off the ground. keep in mind i have a big block and a th400. its heavier than your motor. the back i bought weld on axle perches(mounts) and welded them parallel to my stock ones. then i put the axle on top on my leafs and fliped my u-bolts unside down and remounted it. i installed c-notches just in case i hit my frame. it you use these spindles you will not need to do anything with rotors. all the same components bolt up just like the original peices.

http://www.performanceonline.com/71-...e-2-half-inch/
Posted via Mobile Device

You cut a.coil or a coil and a half? Just to clarify. Also...in your archives do you have any pics from the side after the drop and shorter tires? Ive seen the pics in the thread
Posted via Mobile Device