Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
10-14-2013, 12:08 PM | #27 |
Registered User
Join Date: Jun 2004
Location: Saskatchewan, Canada
Posts: 1,368
|
Re: Best Drag front end to replace factory anchor?
I made it down once before in like 2009 or 10 can't remember, then hadent raced my truck for 3 years but made it out to Saskatoon again this year. I do hope to make it down there again next year, a few of the guys I race with usually make it down at least once a year.
One thing I think that's going to maybe give me problems is getting the steering shaft routed between my headers and frame, will likely have to notch the frame and then strengthen it again some how, that and was going to go with a direct replacement IDIDIT column but have to call them to get a length on it as they don't list the specs and I think a shorter one will make the steering shaft routing easier.
__________________
Speed is just a matter of money, question is how fast can you afford to go? 8.95@148.97mph all motor haven't tried bottle yet Sponsored by: Getz Oilfield Consulting Hard Candy Customs |
Bookmarks |
|
|