Pre-LS swap questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Angryman117 · 11-08-2013, 12:20 AM

The 700R4 and 4L60E are very similar but the cross member on the 60 sits back about an inch or so than the 700. I know this cause I did what you were talking about doing. Thankfully the mounts I have are bolt in and not welded. I was also thinking about getting my drive shaft sized with the 700, good thing I didn't. I got a 99 4L60E from a suburban with the torque converter from a local salvage yard for about $300. How far are you from Hitterdal, MN? I got my engine from there, found on CL for about $550 with everything I need to make the engine run. I am sure they would have a couple of 60's laying around.

11-08-2013, 12:20 AM	#10
Angryman117 Registered User Join Date: Jul 2013 Location: VAFB, CA Posts: 227	Re: Pre-LS swap questions The 700R4 and 4L60E are very similar but the cross member on the 60 sits back about an inch or so than the 700. I know this cause I did what you were talking about doing. Thankfully the mounts I have are bolt in and not welded. I was also thinking about getting my drive shaft sized with the 700, good thing I didn't. I got a 99 4L60E from a suburban with the torque converter from a local salvage yard for about $300. How far are you from Hitterdal, MN? I got my engine from there, found on CL for about $550 with everything I need to make the engine run. I am sure they would have a couple of 60's laying around. __________________ Angryman117's 47 Chevy Build 89 Silverado Z71 LS Swap (sold)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.