|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-19-2014, 03:09 PM
|
#1 |
|
Registered User
Join Date: Oct 2012
Location: Post Falls, ID
Posts: 61
|
Spindle bearing surface marred
When I removed my spindle needle bearings I resorted to a die grinder. Hastily I cut and marred the inside spindle surface a bit. It is in one section and a deep enough divot to feel. My new bearing pressed in tight, Is that anything I should worry about?
|
|
|
| Bookmarks |
|
|
Threaded Mode