^^ drive shaft length - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*Barney 66* · 01-29-2014, 02:25 PM

I have a 66 short bed thats dropped 2 inches in the rear and has a 350 Turbo tranny. Need to know the distance from the pinion shaft center (with the 3/4 inch play) to the the saddle on the rear end. I had to pull my drife shaft our for new U joints and it would not come out without sliding the axle aft... thus my dilema... I cant lower the truck and measure so its either re install everything and drop to the ground and remove the bed to measure or wag it with some help on here. Thanks in advance...

Barney

01-29-2014, 02:25 PM	#1
Barney 66 Account Suspended Join Date: Jan 2014 Location: san diego, California Posts: 130	^^ drive shaft length I have a 66 short bed thats dropped 2 inches in the rear and has a 350 Turbo tranny. Need to know the distance from the pinion shaft center (with the 3/4 inch play) to the the saddle on the rear end. I had to pull my drife shaft our for new U joints and it would not come out without sliding the axle aft... thus my dilema... I cant lower the truck and measure so its either re install everything and drop to the ground and remove the bed to measure or wag it with some help on here. Thanks in advance... Barney Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.