Ididit steering column - can't get low gear - The 1947 - Present Chevrolet & GMC Truck Message Board Network

AUS64c10 · 02-09-2014, 03:03 AM

I fitted a Ididit tilt steering column in to my 64 C10 today. I'm running a TH700r column shift auto with a rod style shift linkage.

I can not get it set up so it will select all gears. If I set it up while the trans is in neutral as per the installation instructions I can't select L1 but can get all other gears.

The column I removed was a 70's chev van tilt column every thing worked with that column but it's totally worn out.

Has any one else had this issue?

02-09-2014, 03:03 AM	#1
AUS64c10 Registered User Join Date: Feb 2013 Location: Melbourne, Australia Posts: 88	Ididit steering column - can't get low gear I fitted a Ididit tilt steering column in to my 64 C10 today. I'm running a TH700r column shift auto with a rod style shift linkage. I can not get it set up so it will select all gears. If I set it up while the trans is in neutral as per the installation instructions I can't select L1 but can get all other gears. The column I removed was a 70's chev van tilt column every thing worked with that column but it's totally worn out. Has any one else had this issue?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.