NC 305 HO 601 heads stainless steel valves

[qksilver]

I have a set of 601 53 cc combustion chamber heads with stainless steel valves, up graded springs and a full on 3 angle valve job.

These heads were magnafluxed, hot tanked, surfaced , all valves replaced with stainless steel valves, new keepers and retainers, 500 lift valve springs, new valve guides and seals.

Good for torque engine builds when you want to keep the compression in a good range for pump gas, or for smaller engine builds to maintain compression
and good power or for circle track when limited to factory steel heads.

I had them on a 327 for a while when they were stock, good torque and no problems with burnt exhaust valves, as the set I replaced them for. Then I went thru them completely and has them on a 283 with 3x2 in my 57 1/2, they also did great. Around 2000 miles, didn't drive the truck very much because of stock steering and brakes

$200.00 plus shipping

drop shipped from 28387 and i will have the weight tomorrow so you can figure out an approximate shipping quote .

Thanks,
Steve