|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-23-2015, 11:20 AM
|
#17 |
|
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: Transmission temperature Gauge
NO, don't just tap into it, that would just ground the low reference circuit to the PCM. Take the M wire out and run a dedicated single wire between there and pin 41. The pins in the trans connector and the PCM are the same, so if you have two extra ones, they will work in either connector.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
|
|
| Bookmarks |
|
|
Threaded Mode