The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-05-2015, 06:42 PM   #1
junk4cash
Registered User
 
junk4cash's Avatar
 
Join Date: Dec 2011
Location: Kansas City, Mo
Posts: 160
Not Level

My 66 has that normal right hand lean that most of these old trucks have but if it were caused by the body mounts, I wouldn't think that I would have the issue I have. I cut one coil off my CPP 3" springs to bring the front end down. On the drivers side, I was about 1/4" from sitting on the bump stop perches. I had already removed the rubber stops. On the pass side, I still had about an inch and a half of clearance. Any idea why I'm so much lower on the drivers side?





junk4cash is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com