Acceleration problem - The 1947 - Present Chevrolet & GMC Truck Message Board Network

LeesTruk · 11-24-2015, 01:26 PM

Ok, I brought my 5.3L to life, and after taking care of some engine swap teething problems (leaking ATF line, and a faulty O2 sensor), the truck will idle cleanly and will easily rev in park/neutral. The problem occurs when trying to drive the truck. While trying to accelerate, it's like someone turns off the engine until I take my foot off the gas pedal, then it comes back to life. Does this sound like a TAC situation? Supposedly the TAC/PCM are from the same vehicle as the engine, as well as the pedal. The only code I have is a P0654 RPM code, but that's most likely my tach hook-up (bad ground), I've seen similar concerns here, but no reply on what cured the problems. Any guidance would be greatly appreciated. Thanks

Lee

11-24-2015, 01:26 PM	#1
LeesTruk Registered User Join Date: Mar 2015 Location: Manchester, CT Posts: 433	Acceleration problem Ok, I brought my 5.3L to life, and after taking care of some engine swap teething problems (leaking ATF line, and a faulty O2 sensor), the truck will idle cleanly and will easily rev in park/neutral. The problem occurs when trying to drive the truck. While trying to accelerate, it's like someone turns off the engine until I take my foot off the gas pedal, then it comes back to life. Does this sound like a TAC situation? Supposedly the TAC/PCM are from the same vehicle as the engine, as well as the pedal. The only code I have is a P0654 RPM code, but that's most likely my tach hook-up (bad ground), I've seen similar concerns here, but no reply on what cured the problems. Any guidance would be greatly appreciated. Thanks Lee



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.