Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
12-15-2015, 11:20 PM | #1 |
Registered User
Join Date: Jun 2014
Location: Littleton
Posts: 41
|
Harness Help....1st attempt!
Hey y'all! Been working on a 2003 Tahoe/C-K harness to make it Standalone. I have questions about that scope outside the 2002 harness re-work on LT1Swap, because his process goes through a 2002 harness without a TAC Module. Not sure about a few wires on the trans too. Any help is appreciate, I am in way over my head on a first swap an no prior experience. I'm close, but no pals to feed beers to for hands on guidance locally!
So: 1) I have 2 Pinks on the Range Sensor, pins C - Ign 1, and E - Starter Relay. Do I need both? 2)Looks ok to remove the LtGrn-ParkNPark, DkGrn-ParkNStart, and Gray-Trailer Brake Lights from the Range Sensor plug. Is that correct? 3) Do I need both Pinks on the Trans Plug, E-Fuse Output Run Crank, and N-Trans Pressure Switch Signal 4) It looks safe to remove the LightBlu- CHM Stop Lamp voltage from the TAC connector plug too. Is that correct?
__________________
Bye bye GenI 350...hello 325 GenIII with a snail!! Last edited by MercRising; 12-15-2015 at 11:25 PM. |
Bookmarks |
|
|