Millermatic 90 vs Lincoln Mig Pak10 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

RyansToy · 01-26-2016, 04:42 PM

I have had a Mig Pak10 for about 5 years. Like it.

Always told that Millers are much nicer.

I found a Millermatic 90 used (broken) on the local forsale forum. Got it for $150. Traced the issues and it will need a new fan. So its going to be about $250 for the welder all in.

The spec's on the two welders are virtually identical; 90ish amps each, 20% duty each, 18VDC.

The miller is 80lbs, and the Lincoln is just 48lbs.

Also the Miller has 5-80ipm vs the lincolns 50-300 ipm (wire feed rate).

Any thoughts on which one to keep?

I am torn between, the lincolns newer, very clean appearance, and the Millers - been around for ages...

Thoughts?

01-26-2016, 04:42 PM	#1
RyansToy Registered User Join Date: Aug 2015 Location: Nova Scotia Canada Posts: 145	Millermatic 90 vs Lincoln Mig Pak10 I have had a Mig Pak10 for about 5 years. Like it. Always told that Millers are much nicer. I found a Millermatic 90 used (broken) on the local forsale forum. Got it for $150. Traced the issues and it will need a new fan. So its going to be about $250 for the welder all in. The spec's on the two welders are virtually identical; 90ish amps each, 20% duty each, 18VDC. The miller is 80lbs, and the Lincoln is just 48lbs. Also the Miller has 5-80ipm vs the lincolns 50-300 ipm (wire feed rate). Any thoughts on which one to keep? I am torn between, the lincolns newer, very clean appearance, and the Millers - been around for ages... Thoughts? __________________ 1968 GMC truck 910 Trim (Canadian) 127" WB 3 on the Three Trans (Saginaw SM330) 250 ci L6 Engine HEI ignition (early 80s L6)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.