New Seats For An Old Suburban

[ironroad9c1]

Originally Posted by Gregski

Have you welded any sheet metal like 16 or 22 gauge, I had trouble with the Mustang floor boards on my '68 the Flux Core wire setup was burning right through on the lowest setting.

yea flux core isnt really good for thin stuff, I could do some exhaust, but it wasnt good for much thinner than that. also as someone said , Slow down your wire and turn up the heat a bit, your welds are pretty cold. Practice to get a feel for how hot you can go before burning through and then back off and speed up the gun a bit .
Kinda like this, This was flux core on the same machine