6.0 Swap w/new Enytropy Radiator/Fans running hot when not moving. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Nodnarb76 · 06-09-2016, 11:47 AM

Still fixing all the little problems after doing my 6.0/4L80 Swap into my 87 Suburban. Along with the motor installed an Enytropy radiator/fan kit.
Fans come on low speed then high speed like they are supposed to.
When I'm driving and have airflow through the radiator, everything is fine, once I come up to a light or stop, temp goes up about 20-30 degrees, even if the fan is on high speed, then goes back down when I start moving. When I installed the motor I replaced the water pump and thermostat with new AC Declo parts.
Any ideas?

06-09-2016, 11:47 AM	#1
Nodnarb76 Registered User Join Date: May 2013 Location: Mississippi Posts: 501	6.0 Swap w/new Enytropy Radiator/Fans running hot when not moving. Still fixing all the little problems after doing my 6.0/4L80 Swap into my 87 Suburban. Along with the motor installed an Enytropy radiator/fan kit. Fans come on low speed then high speed like they are supposed to. When I'm driving and have airflow through the radiator, everything is fine, once I come up to a light or stop, temp goes up about 20-30 degrees, even if the fan is on high speed, then goes back down when I start moving. When I installed the motor I replaced the water pump and thermostat with new AC Declo parts. Any ideas? __________________ 1987 R20 Suburban LQ4/4L80e swap: http://67-72chevytrucks.com/vboard/s...d.php?t=693824



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.