Stainless Rod - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BigDan3131 · 06-16-2016, 12:22 AM

So as is in my usual way I found something else I plan to change from stock. I need lengths of SS rods threaded on the ends only that are around four feet long. I also need a few shorter ones too.
So what these are for is to do away with the stock hood springs and latch and build hood prop rods like the Willys use except two, one for each side. The latches themselves will be revealed after the truck is done since again I'm doing something different

Where can I get them? Should I try Grainger? 3/8"

06-16-2016, 12:22 AM	#1
BigDan3131 Registered User Join Date: Jun 2006 Location: Maple Valley, WA Posts: 1,913	Stainless Rod So as is in my usual way I found something else I plan to change from stock. I need lengths of SS rods threaded on the ends only that are around four feet long. I also need a few shorter ones too. So what these are for is to do away with the stock hood springs and latch and build hood prop rods like the Willys use except two, one for each side. The latches themselves will be revealed after the truck is done since again I'm doing something different Where can I get them? Should I try Grainger? 3/8" __________________ Custom Painter/Restoration Specialist 1965 GMC 3/4 Ton LB SOLD? 1964 Chevy El Camino in full restoration 1991 Chevy S10 288K+ miles 2nd Owner SOLD 2020 RAM 1500 Warlock



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.