WA Parting out 1971 Custom/20 Deluxe 2wd

[randy500]

350 4spd, ran great when parked in 2001, block cracked from freezing.

ALL prices plus shipping!,

First “I’ll take it” gets it. No PM’s that’s a hassle, I will PM you my email address for payment through PayPal. I will do my best to pull and ship within a day of payment and send tracking. I have sold a couple parts here and bought and sold on corvetteforum for many years under the same screen name.

Power Steering, complete $150

Dark Green Interior Parts, ask

4 speed non-tilt column, dk. green - $100

7041208 Quadrajet Carburetor, $150

Air Cleaner $40

Oil fill tube and bracket $25

Power Brake Booster, brackets, braces and rod $125

Tool box for passenger bedside, no rust door $200, door with slight rust $100,
both with hinges, latch, trim, handle, etc.

Fiberglass inner tool storage compartment $50, I also have 2 of these.

Original jack with original foam sleeve containing jack crank rod and the lug wrench $150, I have 2 of these also.

AM radio, tested and working with support arm $50, no knobs or nuts.

Uncut Metal Dash, I have 4 total, 2 A/C and 2 non A/C, unbolted at sides and cut out at the windshield. $150ea

Green Dash pad, some curling at each side on the top, not cracked $100, DECIDED to keep this

Cab light with switch, switch plate and wiring $100, all have some bubbles in the chrome.

Cigarette lighter, bezel housing and wire, $50

Big Block A/C brackets, compressor and partial hose with muffler and clamp, missing over valve cover adjustment arm. $300

Big block power steering reservoir, $75, this is the only bib block P/S part I have.

Big Block Fan Shroud, $150

Black steering wheel, no cracks, with horn button, not much grain on upper portion or end of spokes, shiny and not sun damaged. $200

Auxiliary Battery Tray, nice $100

Camper special wiring?

Inside wiring harness with fuse box $100, engine harness and light harness, $75 each.

4 speed pedals and brake assembly $75

Clutch Rod inside cab to Z bar $35

Z-Bar $35

Frame Bracket $30

Block Ball stud and bracket $25

Z-Bar to clutch arm rod with springs, $25

Outer grill, fairly straight, original rivets, $100

Inside Rear View mirror, very nice stainless, black cover (factory died from green) very nice mirror, very light silvering, $100.

1972 inside rear view mirrors, I have 7 total ,all avg condition, some silvering, offers taken

Chrome front bumper, bare, good for driver or re-chrome to show finish. $200.

High Hump, 4 spd floor $80.

4 spd Shift Boot and trim ring $40

Steering column mount at cab with clamp $25

Ashtray, never used, bright plating, ball bearing guide type, $100

Steering column coupler shaft $35

Heater control, avg originals, good levers and switches $50ea, I have a few of these.

Center consoles, I have 3 of these, average condition, only one has correct seat belt holders. $100ea. The early one with the seat belt holders has a prominent pointy edge where you grab it to open the lid (facory of course, must be an early console thing). That console has a quarter size den/crack. The far left one has one bolt hole in the bottom broken, the blue one is missing the top trim piece, the lid screws and the cable. Essentially I have 2 complete consoles and one that needs work.

I have 4 doors total, all green and white, all have some rust at bottom. I used to scrap doors like this but maybe you could use them? I probably will be keeping the best 2 for my truck.

I think I have a usable drivers fender, light rust in front, passenger is missing the bottom of front from rust.

Core support is shot, no good passenger inner fenders.

If it’s not listed just ask, I don’t have any Cheyenne super parts, bucket seats, tilts or tach’s.

See my WTB post for things I may need and take in trade.

Bucket seat and console floor supports, these are from a blazer, 1975 or so. Should work on a truck since the seats are similar.

Radio Delete Plate $75

TCS wiring, think this is for a 1971, not sure.

TH400 Detent (kickdown) switch and wiring, gas pedal type, think this is from a 72 but could be from a later model, should be about the same. $60.

Photos here...

http://s1376.photobucket.com/user/ra...bile%20Uploads