1951 Flat-Out Engineering suspension

[nineteen51chevy]

Hello, new to the forum and in need of advice/help.

Project is a 1951 Chevy Truck. I have the suspension kit from Flat-Out Engineering installed to utilize the C4 suspension from the 84-87 Corvette.

I installed the provided rear Aldan coil overs but I am concerned with the amount of positive camber I now have. During the install, I put in a piece of bar stock the 11-1/2 from center to center hole. This was to simulate the coil over at ride height. Everything was good with that. But now that the coil over is in things seems all askew. The coil over was an Aldan AS654 with a 400# spring.

Will the weight the bed, fuel tank, and everything else settle the rear back down? I am hoping there are some more that have used this kit.


.

.

.