Door frame seals - The 1947 - Present Chevrolet & GMC Truck Message Board Network

oranedward · 08-28-2016, 02:33 PM

I recently bought a 1959 Apache 3600 that has been partially restored. Mostly it needs dash controls and all door seals. The circumferential seals that I have bought have pins all around the seal. The doors only have holes in the upper half of the door. I cannot see on the inside of the door where any holes have been filled. Should there be holes on the bottom half of the doors and I should (re) drill them? Or, should I just glue the lower part of the seal to the door?

08-28-2016, 02:33 PM	#1
oranedward Registered User Join Date: Aug 2016 Location: Washington, TX Posts: 1	Door frame seals I recently bought a 1959 Apache 3600 that has been partially restored. Mostly it needs dash controls and all door seals. The circumferential seals that I have bought have pins all around the seal. The doors only have holes in the upper half of the door. I cannot see on the inside of the door where any holes have been filled. Should there be holes on the bottom half of the doors and I should (re) drill them? Or, should I just glue the lower part of the seal to the door?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.