The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-14-2016, 12:00 PM   #11
valis4nu
Registered User
 
Join Date: Sep 2016
Location: Omaha, NE
Posts: 8
Re: LS factory cruise control hook up

I am in the process of designing and building a tester module for this model of cruise control module (CCM) as I have replaced it twice on my 92 Buick Roadmaster without success. The only thing I am not sure about is how to simulate the input from the PCM (VSS) that goes into Terminal K (green wire) of the CCM. I know that it is a 5-volt signal, but that is all.

I found a GM video on YouTube regarding this CCM on a 91-93 Buick Roadmaster. It stated that the Speed Sensor Module (SSM) on the driveshaft produces an AC voltage of anywhere from 2-100 VAC. This signal is fed into the Vehicle Speed Sensor (VSS) which in turn feeds Terminal K on the CCM. But the video confused me on one point in that it stated that the voltage of that wire is actually a ratio of 1.1 volts per 1 mph.

Here is the link to that video:
https://www.youtube.com/watch?v=Q5SEy9GwQIw

Advice and suggestions are most welcomed. Thanks!
valis4nu is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:26 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com