|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-14-2016, 10:40 PM
|
#1 |
|
Registered User
Join Date: Nov 2014
Location: between AZ & NV
Posts: 67
|
HEI no spark during crank problem
seems ive read many threads on this issue yet no definite answer has been put out. 3 days ago i got finished putting an RV 454/700r4 in my suburban. Unable to get her fired up. The keyed on 12v wire that goes to the bat + terminal has power. ive tried so far
- connect to 12v junction block - connect directly to the battery - connecting directly to the alternator. Still nothing. HEI has new cap, coil, rotor. Ignition module tested good at autozone. My next move is to run wire directly from the bat + to the starter's R terminal as if this was a points-to-HEI conversion. I just dont see how something do simple can be a PAIN in the ass.   any suggestions would be great.
__________________
*UNDER CONSTRUCTION* '80 Suburban C20 (C6P) (Silverado) - '68 472 (Edelbrock 1813, PH8026 LT's, H pipe) / '91 4L80 (manual shift,vac modulator, 350 converter) / 14B FF 3.21 G80 34' s/ '96 GMT400 interior |
|
|
| Bookmarks |
|
|
Threaded Mode