Swapping over to a stock 283 in my 66....

[Chevystep]

Any picts/descriptions of spark plug wire routing with ram horns? Seen quite a few 327 pictures but not sure the 283 has the same block holes for bolts in the back to mount the plug wire loom dividers. Seems like I'll need really long wires to go back and under, with 1/3 and 2/4 being routed up through the engine mounts. The back near the firewall is getting pretty busy and need to get them out of the way of the throttle rod/lever. Maybe put a couple of 4 wire holders on the firewall to get them out of the way and started down and forward? Some oil pan bolt clips? Use some longer pre '74 Corvette wires (or just make my own)...