I bought a 2011 Camaro for the ls3 and tr6060 to go into my 68 short step side. As I am getting ready to tear into the car to strip the drivetrain I've been daydreaming about the brake setup and was curious about a few things. I've seen some mention of corvette brakes Etc, but nothing as far as this goes. The car has 14" rotors front and rear with brembo calipers. The mount on the front caliper looks similar to the cpp modular drop spindles brake caliper mount. Was curious if anyone had a set so I could borrow measurements to look into it.
Not as concerned about the rear mount, figure I can have a bracket burned and come off the axle tube. Plan currently is to re drill the rotors for 5x5.
05-01-2017, 12:57 PM
Threaded Mode