new rear coils install help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**bigmac73** · 06-02-2017, 04:48 PM

I am installing new trailing arms/ springs and bushings in the rear of my 72 C-10 , in my chevy manual is shows that the end of the coils need to be locked into the tabs on the spring cups.

but the way the cups are orientated to fit in the end of the coil spring i do not see how that is possible and are the cups made different for each side, i ordered 4 and they are all the same?

See pics

the first is the bottom of the coil spring and the other two pics are of the top end of the coil spring , see the tab and the end of the spring.. is this crucial or can i run them as is???

06-02-2017, 04:48 PM	#1
bigmac73 Senior Member Join Date: Mar 2012 Location: Chesapeake, Va Posts: 1,275	new rear coils install help I am installing new trailing arms/ springs and bushings in the rear of my 72 C-10 , in my chevy manual is shows that the end of the coils need to be locked into the tabs on the spring cups. but the way the cups are orientated to fit in the end of the coil spring i do not see how that is possible and are the cups made different for each side, i ordered 4 and they are all the same? See pics the first is the bottom of the coil spring and the other two pics are of the top end of the coil spring , see the tab and the end of the spring.. is this crucial or can i run them as is??? Attached Images __________________ Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks Last edited by bigmac73; 06-02-2017 at 04:50 PM. Reason: additional informatuon



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.