Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-27-2017, 08:58 PM | #1 |
Registered User
Join Date: Nov 2011
Location: South Dakota
Posts: 916
|
Question about drive shaft
Im getting my 5.3/4L60 swap from my old 74 c10 swapped into my 83 c10. My buddy tried fitting the driveshaft that we had made for the 74 but turns out its too long. The engine n tranny are sitting a bit further back in the engine bay of the 83 so thats one reason why.
However the 74 was lowered when we measured to have the driveshaft made n the 83 isnt lowered yet. So my question is does it make a difference if the truck is lowered or not when measuring for a driveshaft? Im taking it to get it shortened tomorrow n also have to swap out the u joint since the 83 has a 10 bolt rear end. Forgot to mention that the yoke is all the way inside the transmission
__________________
1983 C10 Silverado 5.3 swap 1974 C10 lwb 5.3 swap(sold)...http://67-72chevytrucks.com/board/sh...d.php?t=614122 2001 BMW 530i 5 speed 2019 Nissan Titan SV Midnight 1979 Datsun 210 4 door 1980 Datsun 120y(back home in Trinidad) Last edited by ivorton74; 07-27-2017 at 10:03 PM. |
Bookmarks |
|
|