Body work advice needed

[Crash0637]

I am replacing the lower front fenders with patch panels. The drivers fender is where I started, it is the worst. I decided to go ahead use the entire patch panel. After welding it up I realized that I didn't quite get the angles right nor aligned perfectly. Started comparing it the the passengers unmolested side and noticed a problem.

Not sure if I should just hammer and dolly out the low spot or if I need to cut in reliefs or if I should cut off patch panel and start completely over.

I have done some bodywork before, however this is my first major replacement. I caught my error, I want to make it right, just not sure which direction to go in.

Help and advice is greatly appreciated!.

https://ibb.co/nwP7OG
https://ibb.co/ffbnOG
https://ibb.co/mCQE3G