Rear Cab molding mounting question. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rufas · 01-22-2018, 11:37 PM

I can usually figure out how to mount moldings. But this one has me stumped. Is the gray plastic clip mounted on the truck first then the molding snapped on? Or is the plastic clip inserted into the stainless steel molding and somehow snapped to the stud on the cab?

There are also two small 'wings' on the plastic clip. It looks like these will be visible when installed.

All I really understand is the clip is pushed on the stud and the pushed either left or right to lock it on the stud.

Any help will really be appreciated.

TIA
Rick

01-22-2018, 11:37 PM	#1
Rufas Registered User Join Date: May 2016 Location: Fort Mohave, AZ Posts: 370	Rear Cab molding mounting question. I can usually figure out how to mount moldings. But this one has me stumped. Is the gray plastic clip mounted on the truck first then the molding snapped on? Or is the plastic clip inserted into the stainless steel molding and somehow snapped to the stud on the cab? There are also two small 'wings' on the plastic clip. It looks like these will be visible when installed. All I really understand is the clip is pushed on the stud and the pushed either left or right to lock it on the stud. Any help will really be appreciated. TIA Rick __________________ 1970 GMC 2500 700R Trans, RideTech 4 link rear suspension, air bagged on all four corners, factory upper/lower A-Arms, 2 inch drop spindles. 350 SBC 300hp Weiand Supercharger FiTech 30004 EFI



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.