![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Sep 2008
Location: magalia,ca
Posts: 366
|
front crossmember-pre runner bumber Build
Hay everyone id like to share my most recent update to my truck
this idea started out of the blue and a piece of 12in x 3/8in flat plate. it may not be what you like or built the way you woud do it but its 100% my truck and my idea and i think it turned out ok. whole thing is bolt on using factory frame holes (+ some holes) with 1/2in and 5/8ths grade 8 bolts and the bumber can be removed from crossmember. tubing is 1 1/2in .120 DOM only tools used were a welder and and angle grider. hope you enjoy. SO IT STARTS- FRAME WIDTH X12in FLAT PLATE SCORDED AND HAND BENT, SEEMS WELDED UP GROUND DOWN AND SMOOTHED. (MY IDEA WAS A CROSSMEMBER THAT WOULD WRAP AROUND FRONT OF TRUCK FRAME. ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() CROSSMEMBER ALL DONE ![]() ![]() ![]() STARING TUBE BUMBER DESIGN-ANGLE OF 1970 GMC GRILL ![]() MATCHING TUBE ANGLE WITH GRILL ANGLE ![]() THE 2 (OUTER ANGLES) LINE UP WITH INSIDE OF HEADLIGHT BUCKETS ![]() 1/4in PLATE USED FOR FRAME TIE INS ![]() HUGS THE FRAME ![]() ![]() ![]() ![]() NOT ME :-) ![]() DESIGNED IT TO LINE UP WITH BOTTOM OF GRILL ![]() ALL DONE ![]()
__________________
1970 2wd ![]() ![]() ![]() |
![]() |
![]() |
Bookmarks |
|
|