How do you get a nut onto the starter solenoid? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**WorkinLonghorn** · 05-05-2018, 05:43 PM

Chevy 350 installed in truck. I remember attaching the wire from the ignition switch to the solenoid before I mounted the starter because I was aware of the difficulty getting to that little bugger. Unfortunately I didn't have the foresight to include a lock-washer and the wire has come off. I can't remember how to get this wire secured. My fingers don't fit in there and I don't see how to get that little nut on there (not to mention a lock washer) and get it tight. I can manage to get the wire loop connector on there, just not the nut. Any suggestions? Thanks -BA

05-05-2018, 05:43 PM	#1
WorkinLonghorn Senior Member Join Date: Dec 2006 Location: Studio City, Calif. Posts: 2,887	How do you get a nut onto the starter solenoid? Chevy 350 installed in truck. I remember attaching the wire from the ignition switch to the solenoid before I mounted the starter because I was aware of the difficulty getting to that little bugger. Unfortunately I didn't have the foresight to include a lock-washer and the wire has come off. I can't remember how to get this wire secured. My fingers don't fit in there and I don't see how to get that little nut on there (not to mention a lock washer) and get it tight. I can manage to get the wire loop connector on there, just not the nut. Any suggestions? Thanks -BA __________________ '69 GMC C2500 Custom Camper, 8 1/2' bed, New GM 350, NP 435 Close Ratio 4spd. Trans., 3.73 Dana-60 open.Camper and Trailer wiring, PS, PB, AC, tach , three gas tanks, stereo speakers, 2nd owner, Work-Truck supreme.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.