Drive shaft too long after rebuild - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Berlinvet · 07-14-2018, 08:18 PM

Ok, perhaps you guys can straighten this out for me. I pulled the TH400 out of my 68 C10 Long Bed, changed the TC and put the tranny back in. So far so good. Now I cant get the darn driveshaft to fit. It's too long. The crossmember mates with the mount on the tranny and the original bolt holes, so I believe the tranny is in exactly the same position it was before - when I removed the drive shaft without any problems. It is all the way in the transmission, cant get it in any further. What the heck is this black magic?

07-14-2018, 08:18 PM	#1
Berlinvet Registered User Join Date: Jul 2018 Location: SAN ANTONIO, TX Posts: 14	Drive shaft too long after rebuild Ok, perhaps you guys can straighten this out for me. I pulled the TH400 out of my 68 C10 Long Bed, changed the TC and put the tranny back in. So far so good. Now I cant get the darn driveshaft to fit. It's too long. The crossmember mates with the mount on the tranny and the original bolt holes, so I believe the tranny is in exactly the same position it was before - when I removed the drive shaft without any problems. It is all the way in the transmission, cant get it in any further. What the heck is this black magic? Last edited by LockDoc; 07-17-2018 at 05:15 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.