Question: For Those Who Have Installed Polished Angle Strips - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Dan in Pasadena** · 08-17-2018, 06:16 PM

No, NOT for those that put covers over your stock factory angle strips.

QUESTION:

Did you bolt your new angles strips through the bed boards AND the bedsides, or only the bed boards? Final paint is done so, no I won’t be welding the angle strips back on.

I’m now finalizing the re-install and putting carriage bolts through the wood with the angle strips tight against the bedsides. We don’t intend to put ANY bolts through the angle strips into the bedsides. Is this how you did yours?

I COULD put bolts and they’d be hidden by the rear fenders and stake pockets but since there are no bolts on the side when stock, I thought i’d not use any.

Your thoughts?

08-17-2018, 06:16 PM	#1
Dan in Pasadena Senior Member Join Date: Nov 2008 Location: Glendora, CA Posts: 6,343	Question: For Those Who Have Installed Polished Angle Strips No, NOT for those that put covers over your stock factory angle strips. QUESTION: Did you bolt your new angles strips through the bed boards AND the bedsides, or only the bed boards? Final paint is done so, no I won’t be welding the angle strips back on. I’m now finalizing the re-install and putting carriage bolts through the wood with the angle strips tight against the bedsides. We don’t intend to put ANY bolts through the angle strips into the bedsides. Is this how you did yours? I COULD put bolts and they’d be hidden by the rear fenders and stake pockets but since there are no bolts on the side when stock, I thought i’d not use any. Your thoughts? __________________ '55 Big Window Shortbed, Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's Dan's '55 Big Window "Build" - Well, Kinda!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.