Standalone Harness - what to wire in - The 1947 - Present Chevrolet & GMC Truck Message Board Network

cebra · 10-04-2018, 07:59 AM

I am trying to determine what wires from a Gen III DBC standalone harness will come inside of the cab? VSS for the speedo as an example. I currently have my in-cab harness pulled and am rewiring it to a fuse block out of a 92' Blazer since my panel/harness was in rough shape. I am also hard wiring my cluster for the S10 speedo swap while I am in there.

I am trying to figure out what wires are needed to connect to a standalone harness (basically which come inside the cab from the standalone harness), I assume at least one +12V is needed no matter how "standalone" the harness is, fuel pump? etc. Thanks for any assistance.

10-04-2018, 07:59 AM	#1
cebra Registered User Join Date: Jan 2018 Location: Durham, North Carolina Posts: 782	Standalone Harness - what to wire in I am trying to determine what wires from a Gen III DBC standalone harness will come inside of the cab? VSS for the speedo as an example. I currently have my in-cab harness pulled and am rewiring it to a fuse block out of a 92' Blazer since my panel/harness was in rough shape. I am also hard wiring my cluster for the S10 speedo swap while I am in there. I am trying to figure out what wires are needed to connect to a standalone harness (basically which come inside the cab from the standalone harness), I assume at least one +12V is needed no matter how "standalone" the harness is, fuel pump? etc. Thanks for any assistance.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.