Air Intake, what are you guys using on your swaps?

[Putzer]

Good looking intake !!!

Originally Posted by Rich84

Is that a kit for a Silverado? How tight is that elbow? I had to remove my upper shroud because there is not enough room with the factory setup. My engine is slid forward to allow room for the A/C in the lower position. D.D sliders almost all the way forward.

Originally Posted by beaterku

I fabbed up one from a mandrel bend. I am still waiting on another 3.75 to 4" couple to mount the MAF sensor. I also need to fab a bracket to attached it to the radiator mount so it doesn't flop around.

Link to parts for cold air intake:

4" mandrel u-bend: https://www.summitracing.com/parts/sum-623036
7" cone filter: https://www.summitracing.com/parts/sum-239630
3.75" to 4" coupler with t-bolts: https://www.ebay.com/itm/3-75-to-4-S...72.m2749.l2649
4" straight coupler with t-bolts: https://www.ebay.com/itm/BLACK-STRAI...72.m2749.l2649
4" hump coupler with t-bolts: https://www.ebay.com/itm/102mm-4-inc...72.m2749.l2649