|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-06-2019, 07:36 PM
|
#1 |
|
Registered User
Join Date: Mar 2013
Location: SF
Posts: 347
|
pancake/sectioned crossmember question
So I am installing a 1978 c30 crossmember that I sectioned 1.5" out of. Its being installed in my 68 c10. The three vertical holes lined up no problem. The two bolts that go through the side of the frame dont line up with the holes in the frame anymore and only partially line up with the holes that are close to it.
What is everyone doing? welding up the partial holes and re-drilling in the right location? |
|
|
| Bookmarks |
|
|
Threaded Mode