1984 C10 w/ '99 Vortec and goodies

[jared stewart]

Well guys, I have to sell something. I bought this truck planning on keeping it and selling the 3/4 ton I have for sale. I haven't sold it yet, so I thought I'd see if there's any interest in this one. Please feel free to contact me with questions or offers. I have to be pretty open on the price 'cause something has to go. I wouldn't be against parting it out, so let me know if something catches your eye.


Engine : vortec 350
This engine was a factory return from a GMC conversion van. It spun a bearing at 7000 miles. It’s been tore down, crank replaced with a nodular eagle crank and taken to the local machine shop and had the rod reconditioned and the bottom end blueprinted and balanced.

Engine Contains:
• clevelite 77 bearings
• Felpro performance head gaskets
• Felpro oil pan gasket (one piece)
• Edelbrock vortec performer intake polished
• Edelbrock 1406 performer carb
• FlowKooler Waterpump
• Spal Electric Fan w/ painless wiring
• 31" Griffin Aluminum Radiator
• Small Body Dave's HEI Conversion Distributor
• Accel Coil
• Hedman HDT caprice Headers
• Lokar dipstick
• K&N filter
•I have a series 50 3" flowmaster and a 3" cat along with a 2 1/2" to 3" Y collector (not installed)
• Holley electric fuel pump/Edelbrock pressure gauge/regulator
In the Cab
• somone's poor job at replacing driver's side floor pan

Chassis/Body
• Sheet metal isn’t perfect, but pretty good overall
• NEW tail light assemblies
• NEW head lights/headlight bezels (not installed)
• Both cab corners have been done
• Drivers side floor needs some attention
• NEW inner Fenders
• Frame has been POR 15 Coated
• new front breaks
• New front shocks (not installed)
• NEW gas tank, fuel pickup unit, and tank straps


700R4 Tranny with about 30,000 on rebuild

$3,200 asking price. Feel free to make offers.
I have other pictures as well.