12-07-2019, 12:30 PM | #1 |
Registered User
Join Date: Jun 2016
Location: Phoenix AZ
Posts: 429
|
Drive shaft
I was able to reuse the old driveshaft by swapping out yoke. Only issue is I think it may be a tad too short.
When measuring shaft I inserted new yoke and pulled it out 3/4 of an inch. I measured 56”. The old drive shaft is 55”. So it’s an inch too short than what I thought I’d need. The yoke is in about 3” to 3.5”. Is this going to be a problem? I’m not gonna be racing it, but I do expect to drive it frequently and tow cars every now and then. Posted via Mobile Device |
Bookmarks |
|
|