Ball joint disassembly and install

[conoco]

Any guidance for those of you that have changed these before. I just got my new parts in. I bought a press because I needed one anyway. I will take the steering arm back off obviously which suck. My manual says the pickle fork is used to take them off and then the press to put them back on. I was just looking for guidance as this is my first time for this particular job. I have new hubs, brake dust shield, calipers and all the hardware that goes with eacho those. I am looking at sand blasting that part of the axle once the ball joints are out so I can por-15 paint them. I am just not familiar with the disassembly and install for these. Any help would be great.