|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-06-2020, 08:38 PM
|
#1 |
|
Registered User
Join Date: May 2016
Location: Huntsville, AL
Posts: 26
|
Drop spindle turning radius
I installed drop spindles on my 62 today from Early Classic. It seems as though the turning radius is not what it was with the originals. Does this look correct to everyone or am I missing something? Is the spindle supposed to contact the lower control arm where it does? I've jacked up under the LCA to put weight on it so it's not on the jack stand. It just seems like it should turn more than it does.
|
|
|
| Bookmarks |
|
|
Threaded Mode