Swapping Drivers spindle for Passenger - The 1947 - Present Chevrolet & GMC Truck Message Board Network

cerial · 10-26-2020, 03:49 AM

I am building a fun build out of a 94 s10.

Short version to a long story is I want to mount a 04 Saturn Ion (EPS) rack against the back side of the engine cross member with a custom sway bar above it.

But the arms for the steering linkage are in the front.

Is it possible to simply swap the passenger side spindle for the drivers side and vice versa to move those arms to the rear or is there a issue with camber or something else that would not make this work?

Would it work if I swaped the upper and lower control arms (and spindles) from the drivers to the passenger side?

10-26-2020, 03:49 AM	#1
cerial Registered User Join Date: Mar 2014 Location: Ionia, MI Posts: 199	Swapping Drivers spindle for Passenger I am building a fun build out of a 94 s10. Short version to a long story is I want to mount a 04 Saturn Ion (EPS) rack against the back side of the engine cross member with a custom sway bar above it. But the arms for the steering linkage are in the front. Is it possible to simply swap the passenger side spindle for the drivers side and vice versa to move those arms to the rear or is there a issue with camber or something else that would not make this work? Would it work if I swaped the upper and lower control arms (and spindles) from the drivers to the passenger side? __________________ 1991 Metro commuter 1991 s10 future project truck 1987 V10 backup daily/junk truck 1985 K20 Winter beater 1991 R30(squarebody) c/c flatbed towrig 1994 s10 80"wb custom build



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.