'66 3/4 ton 2WD. Need advice on what my front end should have. Didn't get a "before" pic to show what I had.
The LMC parts drawing below shows part 19, brackets, and part 21, U-bolts.
[ATTACH]
[/ATTACH]
I'm trying to figure out where these go, and if I need them at all. The shop manual does not show them unless I'm missing it (which I have been known to do
) It appears that some 1/2" Grade 8 bolts are what hold the shaft to the frame, per my temporary fit below. It this OK as is, or do I need the caps and U-Bolts? If so, where do they fit into the equation? Thanks!
11-09-2020, 09:23 PM
Threaded Mode