Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
06-23-2021, 08:25 AM | #1 |
Registered User
Join Date: Sep 2020
Location: Richmond, VA
Posts: 39
|
Vintage Air RPM Cutout
I thought I'd pass along how I wired up my Vintage Air WOT sensor in case others may find it useful. To set the stage, I'm running an LS3 engine, vintage air A/C and Dakota Digital gauges.
I didn't like the idea of my compressor engaged when I get a wild hair and flog it up to redline of +6K rpm for two reasons. First, the stress on the compressor and secondly the drag on HP. The easy way around this is to simply reach up and turn the A/C off before stomping on it but I've found myself forgetting to do that and I'm all about adding automation. After reading forums until I went crossed eyed on how to send WOT signals from the ECM, I decided to go a different route. I instead used the switched ground "warn" output of the Dakota Digital gauges to trigger a simple relay to power the orange WOT input on the VA system. This method is nice because I can easily set the triggered RPM setting through the gauges. I tested the VA system before wiring it all up and found that whenever it receives power on the orange wire, it will disengage the AC clutch until it no longer has power on the orange wire +5 seconds. I set my cutout at 4800rpm as don't typically shift above that range unless I'm really getting into it. Hopefully this helps others looking for a WOT AC solution.
__________________
66 Build Thread- https://67-72chevytrucks.com/vboard/...d.php?t=814582 |
Bookmarks |
|
|