55.2-59 Rounded bed corners

[mrbuck]

I remember seeing this done somewhere, maybe it was Bam’s build? But anyways here’s how I did it and it came out awesome, in my opinion. With a total cost of 17$ it’s a definite Big Bang low buck project.

Materials needed 1- 1 3/4” tight bend U exhaust pipe, some small scrap sheet metal.
1. Cut U bend exactly in half, this is tough to get square and exactly in half.

2.cut bed rail off 6” back from tailgate. Cut stake pocket 1 3/4 below top of bed rail.

3. Fab a small cap to seal off top of bed post.

4. Fit radius corner to match the bed rails.