|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-17-2023, 03:31 PM
|
#1 |
|
Senior Member
 
Join Date: May 2022
Location: Longwood 59 chevy
Posts: 317
|
cpp 400 rag joint
Getting ready to cut the original column to length and grind to fit the rag joint. Rag joint has two flats spot 180 degrees apart and is drilled for set screws. The holes arent tapped for set screws. I thought they came tapped out of the box. Should I tap them and add indents on the shaft or drill straight thru the shaft and add a double nutted bolt?
|
|
|
| Bookmarks |
|
|
Threaded Mode