|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-01-2004, 06:47 PM
|
#1 |
|
Registered User
Join Date: Apr 2001
Location: Marion, Iowa
Posts: 126
|
Bad vibration at low speed
I just swapped out axles on my 4x4. The rear axle housing is pointing down where the drive shaft hooks on rather than level or elevated a hair. Could this be the cause? The drive shaft is stretched to the max. Could this be the cause? When driving if you put the truck in neutral the vibration goes away. WOuld a bad rear end produce a vibration or would it just make a lot of noise? Any help would be great.
Thanks, Tim
__________________
70 3/4 GMC 4x4, 400sb |
|
|
| Bookmarks |
|
|
Threaded Mode