Lowering - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Norselander · 04-05-2005, 07:40 PM

My '56 3200 is missing the second from the bottom and the second from the top leaves. But I would advise against pulling leaves because you will lose quite a bit of travel and the ride becomes a little sloppy (well, sloppier with a pack that isn't quite as stiff).

You can get a dropped axel (not stretched like a MorDrop) from CenPen or try out a monoleaf setup.

Keep in mind that the inline six is heavier than the small block and that the 3100 frame is lighter than the 3200/3600.

04-05-2005, 07:40 PM	#2
Norselander Clunker Farm, Proprietor Join Date: Oct 2003 Location: Coastal Northern California Posts: 124	My '56 3200 is missing the second from the bottom and the second from the top leaves. But I would advise against pulling leaves because you will lose quite a bit of travel and the ride becomes a little sloppy (well, sloppier with a pack that isn't quite as stiff). You can get a dropped axel (not stretched like a MorDrop) from CenPen or try out a monoleaf setup. Keep in mind that the inline six is heavier than the small block and that the 3100 frame is lighter than the 3200/3600. __________________ Drew Chief Junk Jockey

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.