|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-26-2005, 12:20 AM
|
#1 |
|
Registered User
Join Date: Feb 2005
Location: Sacramento, Ca.
Posts: 30
|
Installing my tach dash, where did the factory punch the grommet hole
I'm exited dudes, new 454 and tach dash
 . Would like it to look factory. Anyone got a pic or description of where the General punched the grommet hole???Thanks! |
|
|
|
04-27-2005, 10:25 AM
|
#2 |
|
Registered User
Join Date: Feb 2005
Location: Sacramento, Ca.
Posts: 30
|
Anyone?
|
|
|
|
|
04-27-2005, 12:09 PM
|
#3 |
|
*Proud Member*
Join Date: Nov 2002
Location: Pittsburgh, PA
Posts: 741
|
my truck's got a factory tach dash. i put a painless system in, which has a wire for the tach signal... and it goes from the guage, through the fuse box to the engine compartment, and i hit the distributor in the harness as i went on by...
no idea where GM put their grommet hole - i have the factory tach harness, but couldn't see where it went through in firewall... there is a small hole by my distributor, but I used it for my oil pressure guage... hope this helps... |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
